The working principle of scrap wire stripping machine

Time：2022-02-16 15:22:24

At present, in the waste wire and cable recycling and dismantling industry, some use manual cutting, some use incineration, and some use special stripping equipment to disassemble waste wire and cable. Whether it is the method of manual cutting or the method of incineration, its efficiency is very low, and when waste wires and cables are incinerated, it will cause serious pollution to the environment. However, the structure of the existing wire stripping machine is relatively complex, which is not conducive to the use of the operator and the later maintenance. For this reason, we propose a wire stripping machine for waste wires.

In order to achieve the above purpose, the present utility model provides the following technical solutions: a waste wire stripping machine, comprising a frame, a first casing and a second casing are arranged above the frame, and a lower part of the frame is arranged There is a bottom plate, the upper surface of the bottom plate is fixed with a motor by bolts, the first shell and the second shell are connected by screws, the inside of the first shell is provided with a peeling device, and the peeling device includes a through hole, the inner cavity of the through hole is provided with a wire stripping blade, the second shell includes an upper shell and a lower shell, the left and right side walls of the upper shell are provided with upper grooves, the The upper casing and the lower casing are fixedly connected by bolts, the corresponding positions of the left and right side walls of the lower casing and the upper groove are provided with lower grooves, and the front side wall of the lower casing is provided with incoming wires The rear side wall of the lower casing is provided with a wire outlet hole, a lower introduction groove is arranged between the wire inlet hole and the wire outlet hole, and an introduction shaft is arranged between the upper groove and the lower groove, and the introduction The shaft is connected to the motor by a chain.

Compared with the prior art, the beneficial effect of the utility model is: a waste wire stripping machine, which can extrude the cross-sectional shape of the wire to be stripped into an ellipse through the extrusion of the upper and lower introduction grooves, and then pass through the ellipse. The through hole increases the stability of the wire during the stripping process and makes the stripping more accurate. By providing stripping blades at the four end points of the through hole, the protective sleeve on the wire can be cut into The four parts are completely separated from the wires, which is convenient for workers to pull out the wires, saves time and manpower, and improves the efficiency of production.